U.S. Medical Development Center For Ritemp Cooling Technology
Novel conformal cooling technology from Ritemp Pty.
Novel conformal cooling technology from Ritemp Pty. Ltd. in Australia is raising its profile on this continent. Mold-Masters Ltd., Georgetown, Ont., recently announced that it had obtained exclusive use of Ritemp technology for hot-runner molds (see April Starting Up). In addition, moldmaker F&S Tool, Inc., Erie, Pa., has formalized an agreement with Ritemp as a designated Technology Development Center for the medical market. Ritemp technology is said to offer much faster cycles, faster startups, and greatly reduced water and energy consumption.
(814) 838-7991 • fs-tool.com
Related Content
-
Improve The Cooling Performance Of Your Molds
Need to figure out your mold-cooling energy requirements for the various polymers you run? What about sizing cooling circuits so they provide adequate cooling capacity? Learn the tricks of the trade here.
-
Why Shoulder Bolts Are Too Important to Ignore (Part 1)
These humble but essential fasteners used in injection molds are known by various names and used for a number of purposes.
-
Where and How to Vent Injection Molds: Part 3
Questioning several “rules of thumb” about venting injection molds.