Shut Off Individual Gates In Multi-Tip Hot Runner

A new manual shut-off feature is available for the Melt-Disk side-entry, hot-tip gating system from Mold-Masters Ltd., Georgetown, Ont.

Related Suppliers

A new manual shut-off feature is available for the Melt-Disk side-entry, hot-tip gating system from Mold-Masters Ltd., Georgetown, Ont. It allows molders to cut off flow from one to seven gates in the 60-mm-diam., radial eight-tip system. This allows continued use of the radial disk nozzle even if the molder does not require all of the tips. The shutoff can be accessed through the front of the tool by turning the shutoff 90°. This feature is not available on the 44-mm Melt Disk with two or four drops. (905) 877-0185 • www.moldmasters.com

Mold-Masters Limited
233 Armstrong Ave. Georgetown, L7G 4X5 Ontario, Canada
Phone (905) 877-0185 Fax (905) 873-2818
 

Editor Pick

Block Cavities and Keep Molding

It goes against conventional wisdom, but molding with blocked cavities can be done while maintaining quality with the help of appropriate in-cavity sensors and process-control software.