Exploring the: Heating & Cooling Zone



« Prev | | Next »

Sort by:


Web Connectivity: the ‘Missing Link’ To Molding Machines & Auxiliaries
Web services technology is being utilized today by many molding companies to enhance their molding operations performance, expand uptime, and obtain supplier support in shorter time for very low cost.
Article Published: 11/25/2013
Optimize Cooling Water Supply To Reduce Distribution Costs
Reducing distribution costs for cooling and chilled water is often one of the easiest and quickest methods of reducing energy use in water cooling, yet most plants have never investigated this area.
Article Published: 9/24/2013
‘ECO-ECONOMICS ’: Harbec Plastics Proves It Pays to Be ‘Green’
Bechtold has spent 15 years in an ongoing quest to prove that manufacturing in a sustainable manner is not opposed to profitability. On the contrary, he says his experience shows that sustainability is an economic opportunity that manufacturers can...
Article Published: 9/24/2013
Conair & Rapid Parent Buys Thermal Care
IPEG, Inc., Cranberry Township, Pa., has acquired Thermal Care Inc., a major manufacturer of mold-temperature controllers, chillers, cooling towers, and pump tanks.
Article Published: 5/28/2013
Measuring the Magic Of Turbulent-Flow Mold Cooling
For decades molding experts have talked about the importance of achieving turbulent flow in mold-cooling circuits. But what is it about turbulence that makes it so important? What can be measured and demonstrated to have some tangible value to molde...
Article Published: 5/28/2013
Troubleshooting Mold Temperature Control
Mold-temperature control is just one of many process elements that can affect the quality of an injection molded part.
Article Published: 1/29/2013
Liquid CO2 Spot Cooling Gets Into Tight Spots in Molds
Cooling of long, thin cores, fillets, slides, ejectors, or other hard-to-reach spots in injection molds can present difficult challenges.
Article Published: 12/28/2012
Optimize Cooling Water Supply To Reduce Costs
In the last three articles (March, May, Sept. 2012), we introduced the problem of wasted energy in cooling-water systems and presented two types of solutions—minimizing “parasitic” heat gains and raising water temperatures to minim...
Article Published: 12/28/2012
Energy Miser: For Energy-Efficient Water Cooling, Raise Temperatures to Cut Demand
Many plants use chilled-water temperatures that are far lower than are actually needed by the process. This has a direct effect on the cost of chilled water.
Article Published: 8/27/2012
U.S. Medical Development Center For Ritemp Cooling Technology
Novel conformal cooling technology from Ritemp Pty.
Article Published: 6/26/2012

« Prev | | Next »


Register Today
All rights reserved. Copyright © Gardner Business Media, Inc. 2015 Cincinnati, Ohio 45244