Exploring the: Heating & Cooling Zone



« Prev | | Next »

Sort by:


Conair & Rapid Parent Buys Thermal Care
IPEG, Inc., Cranberry Township, Pa., has acquired Thermal Care Inc., a major manufacturer of mold-temperature controllers, chillers, cooling towers, and pump tanks.
Article Published: 5/28/2013
Measuring the Magic Of Turbulent-Flow Mold Cooling
For decades molding experts have talked about the importance of achieving turbulent flow in mold-cooling circuits. But what is it about turbulence that makes it so important? What can be measured and demonstrated to have some tangible value to molde...
Article Published: 5/28/2013
Troubleshooting Mold Temperature Control
Mold-temperature control is just one of many process elements that can affect the quality of an injection molded part.
Article Published: 1/29/2013
Liquid CO2 Spot Cooling Gets Into Tight Spots in Molds
Cooling of long, thin cores, fillets, slides, ejectors, or other hard-to-reach spots in injection molds can present difficult challenges.
Article Published: 12/28/2012
Optimize Cooling Water Supply To Reduce Costs
In the last three articles (March, May, Sept. 2012), we introduced the problem of wasted energy in cooling-water systems and presented two types of solutions—minimizing “parasitic” heat gains and raising water temperatures to minim...
Article Published: 12/28/2012
Energy Miser: For Energy-Efficient Water Cooling, Raise Temperatures to Cut Demand
Many plants use chilled-water temperatures that are far lower than are actually needed by the process. This has a direct effect on the cost of chilled water.
Article Published: 8/27/2012
U.S. Medical Development Center For Ritemp Cooling Technology
Novel conformal cooling technology from Ritemp Pty.
Article Published: 6/26/2012
Thrifty California Processor Dries PET with 'Waste' Heat
Southern California can be a challenging environment for manufacturers, not least because of concerns about the cost and availability of electrical power.
Article Published: 4/29/2012
Cooling Water: Minimize Demand by Reducing Heat Gains
In March, we introduced the subject of energy savings through cooling-water management.
Article Published: 4/28/2012
Mold-Masters Gains Exclusive Use Of Ritemp Technology for Hot Runners
Hot-runner supplier Mold-Masters Ltd., Georgetown, Ont., has obtained rights to exclusive global use of Ritemp evaporative cooling technology for hot-runner molds.
Article Published: 3/27/2012

« Prev | | Next »


Register Today
All rights reserved. Copyright © Gardner Business Media, Inc. 2015 Cincinnati, Ohio 45244