Exploring the: Hot Runners Zone



« Prev | | Next »

Sort by:


News in Hot Runners & Tooling at K 2013
Molds that break speed records for specific applications; hot runners for medical, packaging, and automotive parts; temperature and valve-gate controllers; and standardized mold components constitute a large grab-bag of news in the tooling category ...
Article Published: 1/24/2014
Headlines from the K 2013 Show
Here’s just a taste of the innovations on display, a selection of the top headlines not covered in our September show preview.
Article Published: 11/25/2013
Arburg Grabs Spotlight at K 2013
WEB EXCLUSIVE: At K 2013, injection machine builder introduces the Freeformer, a novel machine for additive manufacturing.. But there was plenty to see in hot runners, LSR processing, and lightweighting as well.
Article Published: 11/19/2013
Synventive Owner Buys Männer
Hot runner suppliers unite.
Article Published: 10/25/2013
K 2013 Preview: Injection Molding
Next month’s mammoth triennial plastics show in Düsseldorf, Germany, challenges injection molding machine builders to demonstrate technological leadership in addressing the needs of the marketplace.
Article Published: 8/26/2013
Seven Tips to Maximize Hot-Runner Performance
A complex variety of factors affects the success of processing with a hot-runner system. Nevertheless, you can reduce this complexity and handle many of the issues by addressing a few key issues.
Article Published: 8/26/2013
Milacron Buys Mold-Masters; Nypro Has a New Owner, Too
Two of the industry’s biggest names changed hands last month as mergers and acquisitions continue to grab headlines in plastics.
Article Published: 2/26/2013
Tooling Advances Highlighted At Molding 2013 Conference
Molds and tooling were a big topic at the Molding 2013 Conference in New Orleans this January.
Article Published: 2/26/2013
Do You Still Get Stubborn Surface Defects, Even With Sequential Valve Gating?
Sequential valve gating either eliminates or greatly reduces the flow-front collisions, and resulting knit lines, between a set of nozzles. However, there are still applications using sequential molding where a “ghost mark” or marks occurs on the pa...
Article Published: 7/30/2012
Mold-Masters Gains Exclusive Use Of Ritemp Technology for Hot Runners
Hot-runner supplier Mold-Masters Ltd., Georgetown, Ont., has obtained rights to exclusive global use of Ritemp evaporative cooling technology for hot-runner molds.
Article Published: 3/27/2012

« Prev | | Next »


Athena Controls
PTOnline
Copyright © Gardner Business Media, Inc. 2014 All rights reserved.