Exploring the: Hot Runners Zone



« Prev | | Next »

Sort by:


INJECTION MOLDING: New Hot-Runner Technology for PET Preforms
Mold-Masters presents several new hot-runner developments for PET preform molding at Drinktec.
New Product Announcements Published: 10/24/2013
INJECTION MOLDING: New Hot-Runner Controller, Upgraded Closure & Preform Machines
Husky unveils new member of its Altanium hot-runner controls family, and makes U.S. debut of an enhanced cap-molding system.
New Product Announcements Published: 10/24/2013
INJECTION MOLDING: New Hot Runners & Auxiliary Injectors at K Show
Mold-Masters, Georgetown, Ont., will display new models in two product lines at K 2013 in Düsseldorf this month.
New Product Announcements Published: 9/24/2013
INJECTION MOLDING: Low-Cost, High-Performance Hot-Runner Controllers
Plastic Engineering & Technical Services, Inc. (P.E.T.S.), Auburn Hills, Mich., has introduced the PHRS family of hot-runner temperature controllers, said to “provide outstanding performance at price levels far below any competitive offerings.”
New Product Announcements Published: 1/29/2013
INJECTION MOLDING: Single-Drop Hot Sprue Bushings for Prototyping & Short Runs
New D-Max single-drop hot sprue bushings from DME, Madison Heights, Mich., have two zones of heating with separate thermocouples.
New Product Announcements Published: 2/1/2012
INJECTION MOLDING: Electric Valve Gate Provides Ultimate Needle Control
Sophisticated hot-runner systems can benefit from the new high-performance electric valve-gate system from Synventive Molding Solutions, Peabody, Mass.
New Product Announcements Published: 12/28/2011
INJECTION MOLDING: Unitized Hot Runners
DME Co., Madison Heights, Mich., introduced two new unitized hot-runner systems based on its Stellar and Galaxy lines.
New Product Announcements Published: 8/23/2011
INJECTION MOLDING: Hot Runners for Auto Lighting
Synventive Molding Solutions, Peabody, Mass., has come out with a line of hot-runner systems tailored for automotive lighting such as front and rear lenses.
New Product Announcements Published: 7/26/2011
INJECTION MOLDING: Smaller Hot-Runner Pitch And Two-Piece Edge Gates
Smallest flat line nozzle allows cavity spacing of 5.5 mm.
New Product Announcements Published: 6/27/2011
INJECTION MOLDING: Hot-Runner Control Boasts Rapid ROI
A new modular controller for hot runners reportedly yields an early return on investment by virtue of its accuracy, durability, and operator-friendliness.
New Product Announcements Published: 5/30/2011

« Prev | | Next »


PTOnline
Copyright © Gardner Business Media, Inc. 2014 All rights reserved.