Exploring the: LIM & LSR Molding Zone
|
Sort by: |
- UV Cure Solves LSR Processing Challenges
- Extended cure times for thick parts and temperature sensitivity of pharmaceutical additives are two challenges for silicone molding and extrusion that can be overcome with new low-temperature UV curing technology.
Article Published: 3/27/2012
- Injection Molding at NPE: Speed, Automation & Integration Take Center Stage
- Hot buttons at the show will be multi-component molding, in-mold labeling/decorating (IML/IMD), in-mold assembly, medical molding, liquid silicone rubber (LSR), micro-molding, and high-speed packaging.
Article Published: 2/23/2012
- Elmet Opens North American HQ
- Produces LSR injection molds and dosing systems.
Article Published: 2/23/2012
- Tightening the Screws on Precision Molding Of Thermoplastics & LSR
- Fairly consistent focus of annual conference was how to get better control of the molding process.
Article Published: 2/21/2012
- PolyOne Acquires ColorMatrix
- In late December, PolyOne Corp., Cleveland, completed the acquisition of ColorMatrix Group, Inc., Berea, Ohio, a maker of liquid colors and dosing equipment, colorants and additives for fluoropolymers, and specialty additives for PET and other resin...
Article Published: 1/27/2012
- Getting Into LSR--Part IV: How LSR Tooling Is Different
- Building molds for rubber molding, and specifically liquid silicone (LSR ) injection, can be very challenging.
Article Published: 12/28/2011
- Molding 2012 Conference Hits the Hot Topics
- Medical molding, liquid silicone rubber (LSR) molding, micromolding (even of LSR), energy management, biopolymers, and sustainable, “green” molding—these and more topics of highest interest to injection molders today will be presen...
Article Published: 10/25/2011
- Getting Into LSR Part III-- Choosing a Mixing/Metering System
- Liquid silicone rubber (LSR ) is a two component reactive chemical with a viscous, paste-like consistency.
Article Published: 8/23/2011
- Automation & Waste Reduction: Medical Molder's Prescription for Efficiency
- Vision Technical Molding in Manchester, Conn., doesn’t believe in standing still.
Article Published: 7/26/2011
- Micro Molder & Mold Maker Succeeds by Specializing
- How small is small? How small is micro? How about parts weighing as little as 0.00012 g and measuring no more than 0.038 in. (1 mm) long?
Article Published: 4/24/2011
