Know How - Extrusion

Exploring the: Know How - Extrusion Zone

118 Results for: Article

Sort by:
Published: 10/26/2012

What Output Should You Expect?
You can get a rough estimate of the potential output if you know the drive horsepower of your machine and the thermal characteristics of one of the materials you’ll be running.

Published: 9/29/2012

New Frontier for Single Screw R&D: Mixing & Melting by Extensional Shear
Extensional shear generally has been associated only with twin-screw extruders. However, I am now convinced it can be done with a single moving force (screw) by changing the geometry of the flow field perpendicular to the direction of flow.

Published: 8/27/2012

The Power-Law Coefficient
By referring to the power-law coefficient, the effect of barrel override in the metering section of many screws can be explained and anticipated.

Published: 7/30/2012

Mission (Nearly) Impossible: Estimating Extrusion Melt Temperature
Extrusion processors often ask screw designers to estimate the output and melt temperature of a new design in the works. Projected output of a new screw can usually be estimated fairly accurately. Melt-temperature estimate, however, is another story

Published: 6/26/2012

Get Smarter on Extruder Sizes
Processors tend to recommend a much larger extruder than what’s really necessary for the job and the capabilities of the downstream equipment.

Published: 5/29/2012

What’s the Deal With High-Speed Extruders?
If we are talking about extruder screw speed, how about 1800 rpm? That’s how fast some extruders are running today.

Published: 4/26/2012

Salt and Screw Cooling
With both, watch how much you use.

Published: 3/26/2012

Water, Oil, Air, or None?
There is no one 'best' barrel cooling medium, but there seems to be a shift in the industry toward air cooling.

Published: 2/21/2012

Well, It Worked on Brand X
You need to give your designer a lot more data than that to make sure you get a screw that's right for you.

Published: 1/28/2012

‘Wedging’ Can Cause Severe Screw Wear
In a column I wrote for the July 2011 issue, I discussed the value of conducting “forensic” examination of worn screws when they are removed for clues to design flaws.