Know How - Tooling

Exploring the: Know How - Tooling Zone

80 Results for: Article

Sort by:
Published: 8/17/2015

TOOLING: The Impact of Hydraulics on Tool Design
Here are more tips on using hydraulically actuated devices on your tools.

Published: 7/16/2015

TOOLING: The Impact of Hydraulics on Tool Design
Get a better understanding of their use, proper sizing, and how the tool design and setup in the machine can impact failures in manufacturing.

Published: 7/1/2015

TOOLING: How to Vent Mold Details
Principles to follow in venting bosses, ribs, pins, cores, slides, and lifters.

Published: 5/25/2015

TOOLING: Venting: Where And How Deep?
After last month’s introduction to the subject, let’s get into the details on vent depths, land lengths, and the alternatives to perimeter venting.

Published: 4/27/2015

TOOLING: Venting: A View From the Trenches
Venting is a prime culprit for molding problems, partly because toolmakers and process techs have different ideas of what’s needed.

Published: 3/31/2015

TOOLING: Clearing Up the Mysteries Of Mold Texture
It’s a subject not widely understood by molders and it affects more than just part appearance.

Published: 2/22/2015

TOOLING: What You Can Do About Mold Buildup
It depends on the materials and additives you use, and the kinds of mold detail, but adequate venting, not overheating the material, and mold coatings are your best defenses.

Published: 1/27/2015

TOOLING: Ejectors: Watch That ‘Unsupported Length’
It may be an unfamiliar term, but it’s the key to preventing ejector-pin deflection and breakage

Published: 12/29/2014

TOOLING: Designing the Tool for the Material
To design a mold for the widest processing window and the fewest problems, start by considering the conditions imposed by the material being run.

Published: 11/24/2014

The Importance of Gate Geometry
Gate size and shape—unlike gate location—don’t often get the attention they deserve. Many common assumptions about gate geometry deserve to be challenged