• PT Youtube
  • PT Facebook
  • PT Linkedin
  • PT Twitter
4/5/2017

Bozzelli Offers At-the-Press Injection Molding Training

Originally titled 'John Bozzelli Offers At-the-Press Injection Molding Training at Molding 2017'
Facebook Share Icon LinkedIn Share Icon Twitter Share Icon Share by EMail icon Print Icon

Scientific molding guru John Bozzelli walked a sold-out class through the basics of scientific injection molding at Molding 2017.

Related Suppliers

J

One day before the conference kicked off, Scientific Molding expert, and PT columnist, John Bozzelli held a special sold-out training event at the Polymers Center of Excellence in Charlotte. Using a mold and material supplied by John McDonnell and Nexeo Solutions. Assisting Bozzelli at the press was the Polymers Center’s Amanda Hurd.

Always challenging his students, Bozzelli offered praise (tossing candy underhand for correct answers) and used data to debunk some molding misconceptions. By the second half of the class, and after a tour of the center, Bozzelli’s tie came off as he pressed the class through the lesson. 

 

RELATED CONTENT

  • Calculate Shot Size Vs. Barrel Capacity

    It may seem like a dull topic, but it will overcome the emotional experience that follows when you put a new mold into a machine and you find out there is not enough barrel capacity to make a full shot.

  • Cold Pressed-In Threaded Inserts: An Economical Alternative

    Cold pressed-in threaded inserts provide a sturdy and cost-effective alternative to heat staking or ultrasonically installed threaded inserts. Discover the advantages and see it in action here. (Sponsored Content)

  • How to Stop Flash

    Flashing of a part can occur for several reasons—from variations in the process or material to tooling trouble.


Resources