Extrusion: Gravimetric Blending & Line Control
Moretto’s new 7-component blender with extrusion weight control.
New from Moretto is the DLK Gravico continuous loss-in-weight blender with extrusion weight control to maintain consistent extrudate weight per linear unit. Suitable for film, pipe, profiles, and sheet, the system meters up to seven components. Its Navigator 9000 touchscreen control manages extruder hauloff and screw-speed control, as well as air-ring and gauge control. It samples 4000 times/sec while handling throughputs up to 4400 lb/hr.
Related Content
-
Why Compression Ratio is Important
Compression ratios have been pretty much standardized over the years, based on what has typically worked before. But there are quite a few variables that must be considered in order to get the optimum performance from your screw.
-
Extruder Alignment: Important, but Only Half the Equation
The other half? Aligning and supporting downstream equipment. Here are best practices.
-
Troubleshooting Screw and Barrel Wear in Extrusion
Extruder screws and barrels will wear over time. If you are seeing a reduction in specific rate and higher discharge temperatures, wear is the likely culprit.