Tooling: ‘Eco-Friendly’ Rust Remover & Preventative
Water-based product from iD Additives removes rust and prevents its formation.
It’s water-based, environmentally safe, EPA tested, nontoxic, non-hazardous, non-flammable and non-aerosol. So says iD Additives about its new Eco-Pro 360, which reportedly removes mill oil, flash rust, and white rust without etching. What’s more it provides a protective coating for long-term rust protection and does not need to be removed before the mold goes back into production.
Eco Pro 360 is a new product category for iD Additives, a supplier of colorants, foaming agents, UV stabilizers, and purging compounds. It reportedly “cleans, coats and seals” injection molds, blown film dies, and other tooling. It also can be reused many times after filtering out any rust particles.
Related Content
-
How to Optimize Pack & Hold Times for Hot-Runner & Valve-Gated Molds
Applying a scientific method to what is typically a trial-and-error process. Part 2 of 2.
-
Why Shoulder Bolts Are Too Important to Ignore (Part 1)
These humble but essential fasteners used in injection molds are known by various names and used for a number of purposes.
-
Improve The Cooling Performance Of Your Molds
Need to figure out your mold-cooling energy requirements for the various polymers you run? What about sizing cooling circuits so they provide adequate cooling capacity? Learn the tricks of the trade here.