Single Temperature Controls, Inc.
14201 S Lakes Dr. Ste. B
Charlotte , NC 28273 US
As Seen In Plastics Technology
K 2019 Report: Auxiliaries Stake Their Claim in the Circular Economy
The theme of sustainable plastics pervaded the exhibits at K 2019, even those of auxiliary equipment suppliers, where everything from dryers to blenders to hopper loaders was reimagined as part of a circular plastics process.
Heating/Cooling: TCUs Ready for Industry 4.0
New “smart” TCUs from Single send process data to a Smart Hub and then to a web portal for remote monitoring, control, and service.
NPE2018 New Technology Focus: Foam Fascination
A new physical foaming process and a significant enhancement of the MuCell process attract attention at the show.
Injection Molding at NPE2018: A Showplace for the ‘Smart Factory’
In Orlando, you’ll glimpse the future, and it’s automated and interconnected. But don’t worry, there are plenty of ways for plants of all sizes to get in on these trends.
Molding Foam with a Smooth Surface
Three lines of Yizumi HPM presses are new adapted for the U.S. market. A large, two-platen model is molding MuCell foam with a hot/cold mold process.
Ten Intriguing Injection Molding Technologies of 2015
I know I’m leaving myself wide open on this one. I was asked, “What are the 10 most interesting injection molding technologies of 2015?” I should have pleaded eggnog hangover and politely declined.
AUXILIARIES AT NPE: More Control, Flexibility, And Efficiency
These are key trends in the many kinds of auxiliary equipment displayed at this month’s show. You’ll also see equipment designed to be virtually ‘foolproof.’
‘Passive Variotherm’ Cooling Cuts Cycle Time at Low Cost
A hot/cold molding technique lets the injected melt do the heating while water flow is paused.
Mold-Heating/Cooling Technology Keeps Cosmetic Parts Looking ‘Hot’
New rapid mold-temperature control technology allows molder to eliminate cosmetic defects like knit lines or sink marks in parts that require a glossy finish or feature texturing.
Moldmaker Explores New LSR Molding Technologies
Can liquid silicone rubber (LSR ) be overmolded onto polypropylene?
Auxiliaries at NPE: New Solutions from Material Preparation To Post-Mold Operations
There will be an extraordinary range of new auxiliary equipment on display at the show.
PMC Proves It’s Not Too Late To Pioneer in Medical Molding
Molding medical devices is a high-end business that has proven more resistant to economic swings and to foreign competition than some other plastics markets.
K 2010 Preview, Auxiliaries: Equipment of All Types Debuts This Month at K 2010
From materials drying, feeding, and blending to process heating/cooling, scrap reclaiming, testing, welding, and decorating—the K 2010 show this month in Dusseldorf, Germany, will have news in all categories of auxiliary equipment.
Hot/Cold Thermal Cycling of Injection Molds Heats Up
Injection molders are warming up to the idea of cycling their tool surface temperature during the molding cycle rather than keeping it constant.
Six Things You Should Know About New Eco-Friendly Chillers
If you never paid much attention to what kind of refrigerant is circulating inside your plastics chillers, it may be time you did.
Process Cooling Goes for Performance Plus Affordability
At the NPE 2009 show in Chicago, half a dozen exhibitors showed new cooling equipment that emphasized improved performance at about the same or lower cost.