Hot Runners

Exploring the: Hot Runners Zone

21 Results for: Product

Sort by:
Published: 4/23/2019

Hot Runners: Electric Pin-Movement Control for Large Sequentially Valve-Gated Parts
Initially introduced in 2010 for small-part molding, a new generation of electrically actuated valve gates targets large parts.

Published: 4/23/2019

Hot Runners: Need For Water Cooling of Actuators Eliminated
New cylinder design reduces heat exposure by minimizing surface contact and applying low heat conductivity insulation on support columns.

Published: 4/9/2019

Hot Runners: Range of Ready-to-Install Single Needle Valves Extended
Ready-to-connect system—including nozzle; all the hot runner and connection components; the clamping, frame and nozzle retainer plate; and also the standard parts—can be directly assembled to the fixed mold plate.

Published: 4/7/2019

Hot Runners: Control Features Adjustable Touch Screen
Hasco's H1280 series of controllers come in three sizes, including table top units, operating from 6 to 36 zones. 

Published: 8/15/2018

Hot Runners: Single Valve Gate System Features Compact Profile
By doubling as a locating ring and housing all the mechanics internally, a new valve-gate system greatly reduces mold-height requirements.

Published: 8/8/2018

Hot Runners: Pre-Assembled, Pre-Wired Hot Runners Offer Installation Without Pre-heating
Hot runner system’s nozzles promise a consistent thermal profile and wide molding window without the risk of polymer leakage or accidental cold condition starting.

Published: 3/27/2018

Husky Highlights PET Preform & Hot-Runner Technologies
HyPET 225 system for injection molding PET preforms and its multi-layer co-injection technology featured. 

Published: 3/20/2018

Variety of New Hot Runner Products Featured
Gunther Hot Runner Systems Inc. has a new control unit, power connector, valve-gate system and split-nozzle shaft to share at NPE2018.

Published: 3/19/2018

External Position of Side-Mounted Cylinder Eases Maintenance
If the side-mounted cylinders from HRSflow require maintenance, the maintenance technician can easily repair them without disassembling the mold.

Published: 11/2/2017

Tooling: New Hot-Runner & Mold Components Shown at Fakuma
New standard products for hot runners and mold bases.