Injection Know How
How to Duplicate a Process From Press to Press
To adopt the right approach you must distinguish between machine and plastic parameters.
Read MoreHow to Pick, Remove, and Replace a Nozzle Tip
This small component can cause big problems. Here’s my procedure for picking and replacing yours.
Read More15 Things to Know About Servo-Driven Injection Machines
Drive technology for injection molding machines has been continuously evolving, and servo motors have become widely used in a variety of roles. Here’s what molders need to know about today’s servo drives in terms of cost, performance, maintenance, and training.
Read MorePlastics Technology’s Most Popular Know How Columns in 2016
Temperature, pressure and time ultimately dictate plastics processing so it’s not surprising that Know How columns from industry experts on these topics are consistently among the most popular on our site.
Read MoreUnraveling the Mysteries of Melt Temperature
Infrared technology can provide consistent and accurate readings of melt temperature. Here’s how to use it.
Read MoreTwo-Shot Molding and Tool Design
There are a few variations of the two-shot molding process, and each has implications for tool design.
Read MoreFaster Is Not Always Better—Optimize Your Molding Cycle
It is possible for machines to run too fast, so find the sweet spot where maximum output overlaps with good parts.
Read MoreINJECTION MOLDING: How to Mold Living Hinges With No Flexing Required
Here are the five critical, intertwined components that must be perfected for a living hinge that doesn’t need to be flexed upon ejection.
Read MoreINJECTION MOLDING: Purging: A to Z
Use these steps as a guide to minimize the time and money it takes to switch materials and color on your presses.
Read More