Injection Molding

Exploring the: Injection Molding Zone

262 Results for: Blog

Sort by:
Published: 10/23/2018

Milacron Is First to Integrate iMFLUX into Machine Controller
Integrating iMFLUX low-pressure process into machine controls is a more economical route to faster cycles and improved part quality.  

Published: 10/9/2018

Borealis, R&D Startup Collaborate on Low-Cost, High-Performance, Sustainable Single-Use Polyolefin Foam Packaging
Bocatech’s EcoCore molding technology combined with two key Borealis PP grades produces eco-friendly molded products that require less material.

Published: 9/27/2018

The 2019 Molding Conference: Better Than Ever
We are gearing up for our Molding 2019 Conference, next March 19-21 in Indianapolis. This year, we are adapting the conference agenda to make it even more interesting to as broad a range of molders as possible.

Published: 9/7/2018

Electronic Flow Monitoring Gives Medical Molder a Better Handle on Mold Cooling
Monitoring water flow and temperature in individual channels proves a valuable tool for process validation and troubleshooting.

Published: 9/4/2018

Free Guidance on Molding Resins
Mobile Specs app and website provide processing parameters on thousands of resins … at no cost.

Published: 8/30/2018

It’s a Connected World Now for Pumps, Valves & Drives, Too
New connectivity products from Bosch Rexroth permit digital monitoring of hydraulic systems for remote diagnostics and predictive maintenance.

Published: 8/24/2018

VFD or Servo Drive for Energy-Saving Hydraulics? Why Not Both?
New VFD from Bosch Rexroth at NPE2018 illustrates the merits of VFD versus servo drive for hydraulic pumps.

Published: 8/23/2018

Do You Have Something to Say About Injection Molding?
The annual all-things-injection-conference—Molding 2019—is currently accepting paper proposals for next year’s event.

Published: 8/13/2018

Something for Everyone at Wittmann Battenfeld’s 10th Anniversary Celebration
New injection machines, robots and auxiliaries; plus additional steps toward Industry 4.0 were on display at Wittmann Battenfeld event. 

Published: 7/27/2018

New Webinar: How to Use Simulation to Reduce Material and Part Cost
Register for this free webinar on reducing downstream risk through injection molding simulation software. (Sponsored Content)