Molds & Tooling

Exploring the: Molds & Tooling Zone

178 Results for: Product

Sort by:
Published: 7/10/2019

Tooling: Insulator Block Protects Cycle Counters, Mold Monitors
Progressive Components' new insulator block is designed to install outside of the mold and protect its CounterView and CVe Monitor when molding high-temperature resins.

Published: 7/6/2019

Tooling: Non-flammable Mold Cleaner and Rust-Preventive Spray
This product does not need to be cleaned off the mold, saving time and cutting out hazardous solvents.

Published: 5/10/2019

Cleaning: Dry Ice Blaster Offers Variable Particle-Size Control
Dial in the precise particle size for different cleaning jobs—molds, screws, and parts.

Published: 4/30/2019

Tooling: Flexible, Non-Twisting, Kink-Resistant Hosing
EPDM hose with textile reinforcement can be used to run water or steam.

Published: 4/11/2019

Cell Automates Overmolding, Inspection of Hypodermic Needles
Moldworx designed a mold, end-of-arm-tooling and automation cell to automate production of hypodermic needles, replacing manual post-mold gluing.

Published: 4/9/2019

Tooling: Locking Cylinder Features Compact Design
By eliminating the need for side locking of the slides, a new cylinder’s simplified design features fewer components, which saves space and installation/repair time.

Published: 3/10/2019

Tooling: First Mold Cleaner with Only EPA-Exempt VOCs
Slide Products spray-on mold cleaner meets or surpasses EPA and California CARB standards.

Published: 3/1/2019

Tooling: System Clears & Prevents Rust in Cooling Lines
The mobile pump/filter unit cleans molds’ internal cooling passages with an eco-friendly rust remover and preventative.

Published: 12/10/2018

Tooling: ‘Eco-Friendly’ Rust Remover & Preventative
Water-based product from iD Additives removes rust and prevents its formation.

Published: 11/10/2018

Mold Release: Paintable, FDA-Compliant Powder
New Dry-21 paintable PTFE powder mold release is a low-residue, spray-on release with FDA compliance for incidental food contact.