Robot Synchronizes Movement with Machine for Faster Takeout
The new “synchronous motion” function from KraussMaffei Automation reportedly shortens demolding time by up to 35% while allowing up to 6% faster cycles.
KraussMaffei Automation, the robotics division of the Münich-based supplier of plastics processing machinery, has introduced “synchronous motion”, allowing robots to synchronize with the ejector function of a molding machine and enter a mold while the platens are still in motion. KraussMaffei notes that in addition to speeding up the molding process, this also reduces the need for pneumatic systems.
KraussMaffei says that normally, a robot does not receive the enable signal until the mold is completely open. Using the “synchronous motion” function allows for earlier entry of the robot so that it arrives at the removal position during the opening movements of the machine.
Beyond keeping nonproductive time as short as possible, KraussMaffei notes that this technology can also make it possible to eliminate complicated gripper hardware. Ejector movement can be used for difficult-to-demold parts with the robot gripping the finished part during the demolding process as the ejector pushes the component onto the gripper. This requires a pneumatic system for the gripper during this “depressurize” step. If, however, the gripper moves along with the ejector, no pneumatic system is required. Depending on the complexity of the application, the synchronization can align with the clamp, part or ejector movement, allowing molders to define the degree of optimization.
KraussMaffei reports that synchronous motion enables demolding time to be reduced by approximately 35%. In the production of trash containers, for example, KraussMaffei says this reduction in demolding time equates to a 6% reduction in the total cycle time. In terms of impact on profitability, the company says the resulting boost in production can increase turnover up to 5% for pallets and up to 4% for crates.
KraussMaffei offers synchronous motion both for new machines and as retrofits for the MC6 controls on existing machines. It works with KraussMaffei’s LRX series linear robots and its IR industrial robots.
With the synchronous motion function from KraussMaffei, the gripper of the robot starts faster, saving valuable cycle time
Photo Credit: KraussMaffei
Related Content
-
50 Years of Headlines … Almost
I was lucky to get an early look at many of the past half-century’s exciting developments in plastics. Here’s a selection.
-
A Cost Saving Modular Approach to Resin Drying Automation
Whether implementing a moisture-sensing closed-loop system for a single dryer, or automating an entire plant, technology is available to take the guesswork and worry out of resin drying. Using a modular approach allows processors to start simple and build more capabilities over time.
-
Cobot Creates 'Cell Manufacturing Dream' for Thermoformer
Kal Plastics deploys Universal Robot trimming cobot for a fraction of the cost and lead time of a CNC machine, cuts trimming time nearly in half and reduces late shipments to under 1% — all while improving employee safety and growth opportunities.
